The commands /showfps and /showCamPos are broken

frtoaster

Submitted on Tribble as ticket #49,562

The command "/showfps 1" should display the frame rate in the upper right-hand corner, as shown the screenshots below.

http://i.imgur.com/qzNW0Qs.jpg
http://i.imgur.com/LhZ4851.png
http://i.imgur.com/RgCfAsC.jpg

The command "/showCamPos 1" should display the camera position and angle, along with other information, in the upper right-hand corner, as shown the screenshots below.

http://i.imgur.com/B2m6bPm.jpg
http://i.imgur.com/b8G7N5u.png
http://i.imgur.com/p6qTv5E.jpg

Neither of these commands works anymore. Furthermore, their default settings have changed. If /showfps or /showCamPos is run with no arguments, the chat window will display the command's current setting: either 1 for "on" or 0 for "off". The default setting for /showfps and /showCamPos used to be 0; the new default is 1. However, even when /showfps and /showCamPos are set to 1, no information is displayed in the upper right-hand corner.

Running commands

To run a command, type the command in the text input box of the chat window and then press the Enter key. Commands given in quotes should be typed without quotes.

Steps to reproduce

1. Log on to any character.
2. Run "/showfps" and "/showCamPos". The chat window will display the following output:

[System] showfps 1.000000
[System] showCamPos 1

3. Go to a ground map.
4. Run "/showfps 1" and "/showCamPos 1". Look at the upper right-hand corner of the screen. No frame rate or camera information is displayed.
5. Go to a system space map and repeat step 4.
6. Go to a sector space map and repeat step 4.

batlham73

use /hideDevUI 0 before you use them