test content
  • Games
  • Social
  • Arc News
  • Support
  • Zen
What is the Arc Client?
Install Arc
Forums > Home› The Foundry for Star Trek Online› The Foundry for Star Trek Online - Bug Reports

Foundry publish wont start

deaftravis05deaftravis05 Member Posts: 4,885 Arc User
edited November 2023 in The Foundry for Star Trek Online - Bug Reports
it's stuck at 0.00 and won't start.

what's up?
Post edited by baddmoonrizin on

Comments

  • cyconianlordcyconianlord Member Posts: 60 Arc User
    edited November 2014
    One of mine is also doing this. Except after a few minutes of not starting, it stops trying and says Publish Failed.

    ST-HSTQKFDD3
  • djxprimedjxprime Member Posts: 522 Arc User
    edited November 2014
    This has been an ongoing issue for some of us for the past couple of months now. two questions: 1) When this happens do you also get disconnected? and 2) Have you also had any trouble previewing any maps in the missiuons you've tried to publish?
    Kkerp5u.jpg?1

    "No matter where you go...there you are."
  • cyconianlordcyconianlord Member Posts: 60 Arc User
    edited November 2014
    I have not had it crash/disconnect. I also just loaded it to try the maps, n i haven't had any trouble previewing its maps.
  • timv94timv94 Member Posts: 20 Arc User
    edited November 2014
    Got the same problem, 0.00% then "Publish Failed".

    ST-HT9S37C4Q
  • deaftravis05deaftravis05 Member Posts: 4,885 Arc User
    edited November 2014
    djxprime wrote: »
    This has been an ongoing issue for some of us for the past couple of months now. two questions: 1) When this happens do you also get disconnected? and 2) Have you also had any trouble previewing any maps in the missiuons you've tried to publish?

    no errors with the map at all.
  • deaftravis05deaftravis05 Member Posts: 4,885 Arc User
    edited November 2014
    nothing on this?
  • cyconianlordcyconianlord Member Posts: 60 Arc User
    edited November 2014
    cyconianlord wrote: »
    One of mine is also doing this. Except after a few minutes of not starting, it stops trying and says Publish Failed.

    ST-HSTQKFDD3

    Mine just pushed through finally.
This discussion has been closed.