test content
Logo
What is the Arc Client?
Install Arc
Subsystem Targeting
orilllian
Member Posts: 0 Arc User
After testing subsystem targeting a bit I have noticed that I am missing most of the benefits from my flow caps.
Target Shields 1 Skill states:
To target: -55.7 subsystem power for 15 seconds
However when applied to a weapon ends up as
To target -33.2 Shield Power Setting
The same happens to Target Shields 3:
To target: -92.8 Subsystem Power for 15 sec
When active on a weapon
To target -49.8 Shield Power Setting
The while the tooltip on the skill seems fine but the end result seems to be getting a much smaller benefit from flow caps and a waste to slot higher versions compared to a science ships free selection.
Target Shields 1 Skill states:
To target: -55.7 subsystem power for 15 seconds
However when applied to a weapon ends up as
To target -33.2 Shield Power Setting
The same happens to Target Shields 3:
To target: -92.8 Subsystem Power for 15 sec
When active on a weapon
To target -49.8 Shield Power Setting
The while the tooltip on the skill seems fine but the end result seems to be getting a much smaller benefit from flow caps and a waste to slot higher versions compared to a science ships free selection.
Post edited by orilllian on
0
Comments
It seems like target shields is the only one effected by this error.
Target engines, aux and weapons all function correctly and give the correct amount of power drain to the beam array.