test content
What is the Arc Client?
Install Arc

server not responding on map change

SystemSystem Member, NoReporting Posts: 178,019 Arc User
I read all the other thread but most seemed not the same as my issues. I stay connected fine till I change map/instant, such as beaming to a planet, or leaving mission area to go back to the starmap, etc. Not lag at all, but about 50%-90% of the time I get "server not responding" after leaving areas. Sometime it goes for 3-4 seconds before going back to login screen, other times it goes up to 20 seconds before going back to login.

Did a tractnet and used the nettest, here's the link to the screen shots.

tracenet.jpg
tracenet2.jpg
Nettest
Post edited by Unknown User on

Comments

  • Archived PostArchived Post Member Posts: 2,264,498 Arc User
    edited May 2011
    based on your tracert and nettest looks like your connection to the server is not the cause of the problem. can you post a dxdiag report?
  • Archived PostArchived Post Member Posts: 2,264,498 Arc User
    edited May 2011
    yeah, here it is.
  • Archived PostArchived Post Member Posts: 2,264,498 Arc User
    edited May 2011
    Does this delay occur on all map changes or only for foundry missions? Foundry missions use the dynamic map server, which downloads the custom map to your machine each time you load it and takes much longer than Cryptic made missions.
  • Archived PostArchived Post Member Posts: 2,264,498 Arc User
    edited May 2011
    devast8tor wrote: »
    Does this delay occur on all map changes or only for foundry missions? Foundry missions use the dynamic map server, which downloads the custom map to your machine each time you load it and takes much longer than Cryptic made missions.
    haven't played any foundry missions yet, it's all been Cryptic made Content
Sign In or Register to comment.