I am sure this is just some teething issues in preperation for MVAM but my prometheus class has a floating piece just about the saucer section which I would assume is the nacelle section for the saucer part during MVAM. But the thing is, its not attached to anything, just floating and is always up.
Another issue I have found is the starfleet decal along the lower engineering hull on one side, the two red stripes past the starfleet logo stretch out off the hull.
Sorry if this is a known and in the works to be fixed, but it is very obvious when looking at my ship and I don't see why it would of been neglected when it was patched into holodeck.
I am sure this is just some teething issues in preperation for MVAM but my prometheus class has a floating piece just about the saucer section which I would assume is the nacelle section for the saucer part during MVAM. But the thing is, its not attached to anything, just floating and is always up.
Another issue I have found is the starfleet decal along the lower engineering hull on one side, the two red stripes past the starfleet logo stretch out off the hull.
Sorry if this is a known and in the works to be fixed, but it is very obvious when looking at my ship and I don't see why it would of been neglected when it was patched into holodeck.
The issue is that the lower engineering hull is almost nothing like the Prometheus.
Comments
The issue is that the lower engineering hull is almost nothing like the Prometheus.