test content
Logo
What is the Arc Client?
Install Arc
FC.31.20210105.10 - High Noon Week 2
kaiserin
Posts: 3,185 Cryptic Developer
High Noon
Perks
- Added Western Pistol 2 and 3 costumes to the event store.
Perks
- Updated several acton figure perks to complete if you unlocked them instead of trading them in.
Post edited by kaiserin#0958 on
0
This discussion has been closed.
Comments
Odd that there is no new "complete 5" aspect for 2nd week. Going to be a pretty dead week.
We have a sombrero and poncho costume already
Click here to check out my costumes/milleniumguardian (MG) in-game/We need more tights, stances and moods
They look so small as to be completely inoperable. I wish the devs could be more consistent with scale of costume pieces
Click here to check out my costumes/milleniumguardian (MG) in-game/We need more tights, stances and moods
Same. Shoes/boots are the worst offender here. Some have little narrow knife-shaped feet that are going to end up looking like skis if you get them wide enough not to look ridiculous. Others are unbelievably fat. Both extremes end up almost unusable. Dividing the "Feet" slider into "Foot Length" and "Foot Width" would be a saving grace.
Eh, i feel like you've never actually held or seen a late 19th century revolver before. These are realistically sized, rather than grotesquely over-sized like every other weapon in the game. If anything, they're *too long*.
late 19th century colt revolvers: https://c8.alamy.com/comp/TA23PC/colt-revolver-from-the-19th-century-TA23PC.jpg
And those would be on the larger size of pistols in that period. (They had pepperbox pistols, after all, which were tiny).
These holsters and the guns in them are too small. The proportions of the guns look good, but the scale is off. When you can't fit a finger between the trigger guard and the trigger then that's a good indicator. As is the fact that the grip would be dwarfed by average sized toon hands.
Click here to check out my costumes/milleniumguardian (MG) in-game/We need more tights, stances and moods
The scale problem isn't really the gun, its the hands. The hands are oversized relative to the body. The gun is pretty realistically proportioned, not just relative to itself, but relative to the nominal scale of the game. It's the hand scale that's out-of-whack.
But since the model is what they used as default...then it should be scaled to that model.
So yes...the scale is off.
I agree with zenith, jonesing and Jackie there. I use as realistic proportions as I can for my characters, including hands, and those guns just don't match, sizewise.
I am not a fan of oversized guns in CO either, but these are doll size. They overshot the mark...pun not intended
Sure there's a defined scale size in game. You can determine it off body height, which is set in feet and inches. And the default model is 6' tall. So, for example, in the preview image above on my screen, that 6' body is 3" tall on my screen. The pistol is just shy 5/8" long. 1" = 2', so 5/8" * 2' = 1.25' or 15" of real length (Actually a little shy of 15", since its not quite 5/8").
An 1860 Colt Army Revolver (most representative gun) has an 8" barrel and is 14" long total. Shy of 15" is just about right! Longer would be too long. And since the internal scale is pretty good, that means it's almost perfectly sized.
The only real problem with the gun model is the position of the trigger inside the trigger guard. The artist for some reason thinks that triggers are nearly centered in the trigger guard. They're not. It should be farther back towards the stock, which would create enough room for a reasonably sized finger to easily fit in that trigger guard. (They should also be rounded, not square, for representative western pistols, but style choices are style choices). But since that kind of detail is virtually invisible for most game purposes, this is at best a minor flaw in an otherwise great looking piece.
No, the primary problem is the hands are not to scale with the body. It's the hands that are wrong, not the pistol.
I happen to think they look fine in game. If you don't like it, you have a hand slider, scale your hands down to something somewhere below oversized-gorilla.
> I happen to think they look fine in game. If you don't like it, you have a hand slider, scale your hands down to something somewhere below oversized-gorilla.
I already commented that I use realistic proportions for hands rather than oversized hands so your point is... pointless
So, weapons in hand scale with hand sliders. (In particular, for pistols, length scales with hand length and height scales with hand).
With 65 hand length and 75 hands, which looks pretty realistic, the hand-held pistol is almost the same size as the holstered pistols. (It's still slightly long, but you'd have to really look to notice the difference, and I'm sure slightly smaller hands would look fine too, so i could nail it exactly if i really cared to spend the time).
And a finger even fits through the trigger guard at that scale. (I'm sure the trigger is inside the finger, since its out of place, but you can't even see that).
Edit: And it looks great, btw.
The former are very obviously smaller... So small as to look unusable . As I and others have previously pointed out
Handheld weapons scale with the hand sliders. If you use realistic hand scale, they will literally be the same size.
You can't claim the holstered ones are very obviously smaller when the hand held ones can be scaled up and down (and even to sizes smaller than the holstered ones). More importantly, if you use a realistic hand size, they're virtually identical in size to the holstered ones.
This mostly proves the default hand size is way too large, since the holstered ones are properly scaled to body height.
(Edit: I've been working with a 6' tall male frame with reasonably standard chest slider, which is what my calculations of gun size used to show it was about right for an 1860 Army Colt Revolver. Obviously body sliders will affect the size of holstered pistols, and apparently female breast sliders also affect the chest holsters).
Weapons having their own sliders would be really nice! Try bulking up a male character with the bodymass slider, and watch the weapon they are holding become smaller and smaller in relation to the character. Chunky dudes can't have nice nice things is the message being sent.. and it's a DISCGRACE! XD
I might also consider the 1860 Colt Army Revolver, which is similar in size to the Walker and Dragoon, although i think slightly narrower. (The Walker is slightly longer, the Dragoon slightly shorter). Regardless, to within reasonable measurement error, the holstered pistols are about the right size for any of these three.
The later Colt Single Action Revolver (~1875) is clearly not the model used.
Well, weapons don't actually change size in the real world, so as a man 'bulks up', weapons do become smaller relative to their mass. (And are relatively larger compared to smaller men). If only all sliders didn't modify holstered weapon size. (In particular, for the holstered pistols, the sliders which are especially egregious are leg length for the hip holster, and the female breast slider for the chest holster).
For handheld weapons, the problem is you can either scale weapons to the body or the hands, because the hands aren't scaled to the body. In fact, hands are ~2x too big by default, which is a substantial difference. (Be nice if weapons didn't scale to hand size at all, in fact, but then it would be really obvious how monstrously oversized hands are).
Edit: reversed relative lengths of Dragoon and Walker, fixed.